5
AHT-E300 ADSL ROUTE
R
The connection diagram below is the example that you can configure network using AHT-
E300 ADSL Router. Install and connect your AHT-E300 ADSL Router in order as follows:
1. Connect the
Power
Connect the AC Power Adapter cord into the power jack on the rear
panel of the AHT-E300 ADSL Router and plug the adapter into the
power source. Check the Power LED is flashing.
2. Connect the
Micro-Filter
To use the phone service and ADSL service simultaneously, install
the micro-filter to the wall-jack.
3. Connect the
ADSL Line
Interconnect the supplied RJ-11 cable between LINE port of the
modem and ADSL port of the micro-filter.
4. Connect the
RJ-45 Straight
through cable
Interconnect the supplied RJ-45 Straight-though Ethernet Cable
between LAN port of the modem and LAN port of the PC or Mac.
Hardware Installation
Warn ing : If you don’t use the micro-
f
ilter to your phone service, the
s
ervice quality of phone service may be degraded.
General ADSL Connection Setup #1
Warn ing : Use the supplied power adapter (DC 14V) only to
p
revent the permanent failure of AH
T
-E300 ADSL Router.
RJ-45 Straight
Trough Cable
AHT-E300
RJ-11
Cable
Micro
Filter
ADSL
Phone
LINE
LAN Power Jack