Sharp AR-156 appendix Bypass Feed including special paper

2

Making copies

BYPASS FEED (including special paper)

The bypass tray can automatically feed up to 50 sheets of standard copy paper and can also feed special papers such as transparency film and labels one sheet at a time. Copy paper measuring from 3-1/2" x 5-1/2" to 8-1/2" x 14" and in the weight range of 14 to 34.5 lbs. can be used in this tray. (For paper weighing from 28 to 34.5 lbs., 8-1/2" x 11" is the maximum size.)

Place the original(s) face up in the document feeder tray or face down on the original table.

The original image must be smaller than the paper or media for copying.

If the original image is bigger than the paper or media, this may cause smudges on the edges of the copies.

Open the bypass tray and extend the tray.

To close the bypass tray, perform step1 and then step 2 in the illustration and push the round projections at the right of the tray until the tray clicks into place.

Set the paper guides to the copy paper width. Insert the copy paper (print face down) all the way into the bypass tray.

●Paper must be fed narrow side into the feed slot.

●Transparency film, labels, and other special purpose papers must be fed

individually.

● When copying onto transparency film, remove each copy promptly. Do not let copies stack up.

●When loading an envelope, make sure that it is straight and flat.

18