Sharp Comprehensive Guide for AR 5316E All in One Printer

1	PRINT
	Basic Printing

If the tray runs out of paper during printing

Add paper to the tray or press the [TRAY SELECT] key () to select a different tray, and then press the [ON LINE] key ( ) to resume printing.

Note that if the "Auto tray switching" setting in the user programs is enabled on a model that has two or more paper trays and there is the same size of paper in another tray, the machine will automatically switch to the other tray and continue printing.

Pausing a print job

To pause a print job during printing, press the [ON LINE] key ( ) on the operation panel to switch the machine off-line. Printing will be paused and the ON LINE indicator will blink.

●To cancel a print job, press the [CLEAR] key () or the [CLEAR ALL] key ().

●To resume printing, press the [ON LINE] key ( ) to switch the machine online.

Caution	When the machine is connected to your computer using
	the USB 2.0 (Hi-Speed) ports on each, be sure to read
	"System requirements for USB 2.0 (Hi-Speed mode)" in
	the Operation Manual.

(part 2)

When "Paper Source" is set to "Auto Select"

If "Paper Source" is set to "Auto Select" in the "Paper" tab of the printer driver setup screen and the correct size of paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "Use Close Paper Size" setting in the user programs (see "USER PROGRAMS" in the Operation Manual).

When "Use close paper size" is disabled

The PAPER SIZE indicator on the
operation panel will blink. You can press	A3
the [TRAY SELECT] key ( ) to select a
	A4
tray manually, or load paper in the	A4
bypass tray and press the [ON LINE]	A5
	B4
key ( ) to begin printing.	EXTRA

*The paper sizes that appear in the

operation panel will vary by country and region.

When "Use close paper size" is enabled

Printing will take place using a size of paper that is close to the size of the print image.

● When the dual function board is installed, the print

Note	image is automatically rotated to fit the paper in the
	event that the paper is loaded in an orientation different
	from the print image.

●If the dual function board is not installed, be sure to set each tray's paper size in "Set Tray Status" in the "Configuration" tab of the printer driver setup screen. (See "CONFIGURING THE PRINTER DRIVER" in the Software Setup Guide.)

When printing, be sure to specify a tray other than "Auto Select" in "Paper Source" in the "Paper" tab of the printer driver setup screen.

C O N T E N T S I N D E X 6