10
INSTALLING THE SOFTWARE
11
When the interface selection screen
appears, select "Parallel" and click the
"Next" button.
12
Select the printer port and click the
"Next" button.
Select "LPT1" for the printer port.
13
When the model selection window
appears, select model name of your
machine and click the "Next" button.
For the model name of your machine, see
"PART NAMES AND FUNCTIONS" in the
operation manual for copier.
14
Click the "Next" button.
In Windows 95/98/Me/NT 4.0, click the
"Yes" button.
Begin installation of the printer driver.
15
When "The installation of the SHARP
software is complete" appears, click the
"OK" button.
16
Click the "Close" button.
A message will appear instructing you to
connect the machine to your computer.
Click the "OK" button.
17
Turn off the power of the machine and
your computer, and connect the
machine to your computer with the
parallel cable. (p. 12)
After connecting the machine to your
computer, turn on the power of the machine
and then start up your computer.
This completes the installation of the
software.
After installation, see "CONFIGURING THE
PRINTER DRIVER" (p. 13) to check the printer
driver settings.
If "LPT1" does not appear, another printer
or peripheral device is using LPT1. In this
case continue the installation, and after the
installation is finished, change the port
setting so that the machine can use LPT1.
This procedure is explained in "Another
printer is using the parallel port (when
using a parallel cable)" on page 15.
Note
After the installation, a message
prompting you to restart your computer
may appear. In this case, click the "Yes"
button to restart your computer.
Note
!!install_ar230270.book 10 ページ 2004年2月19日 木曜日 午後1時17分