INSTALLATION MANUAL
INSTALLATION
•Review and plan ahead all safety instructions, cabinet clearances and dimensions, power supply placement and electrical requirements before installing.
•Proper installation is the responsibility of the installer and product failure due to improper installation is not covered by warranty.
Note: This appliance must be properly grounded
Attention Installer: This appliance must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on this product.
ASELECTING 208 OR 240 VOLT CONNECTION
This appliance can be set for 208V or 240V. The voltage setting for your appliance is
1Locate the voltage switch on the left side of the appliance (facing the front). See Figure 4.
2Remove the screw and rotate the switch plate 180˚ as indicated in the Figure 5.
3Reinsert the switch plate and replace screw as indicated in Figure 6. The voltage setting is indicated by the visible marking.
Figure 4
Screw
240V | 208V |
Screw | 180˚ |
|
Figure 5 | Figure 6 |
BADJUSTING
Measure the thickness of the counter. See Figure 7. Locate the
Measure thickness
Figure 7
Loosen screws to adjust
Back of unit
Figure 8
Countertop thickness +1/16" from bottom of cooktop glass bracket
to top of
Figure 9
4