CAUTIONS CONCERNING THE USAGE OF THIS PRODUCT
•Do not block the intake and exhaust ports.
•Do not use the unit near or on hot objects, such as a stove, etc. Also, do not use the unit where it may come into contact with steam.
•Do not use the unit on its side.
Deformation, malfunction and/or overheating of the motor may occur as a result.
•Do not install when there is generation of lampblack, such as in a kitchen, etc.
•Do not use detergent when cleaning the unit. The unit surface may become damaged or cracked. In addition, the sensors may malfunction as a result.
•When transporting the unit, always hold the handle on the back of the unit.
Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in bodily injury.
CAUTIONS WHEN MOUNTING THIS PRODUCT TO A WALL
•A wall side to install is to choose the place to have the strength done firmly.
•Never mount the unit to a thin wall or plasterboard of insufficient strength. The unit may drop as a result.
•When mounting the unit to a wall, remove the front panel and hold the main unit.
Holding the front panel may cause it to become detached, thus dropping the unit and resulting in bodily injury.
•Do not install when there is generation of lampblack, such as in a kitchen, etc. The unit surface may crack or the sensors may malfunction as a result.
CAUTIONS CONCERNING THE INSTALLATION
DO NOT USE THE REMOTE CONTROL IN THE FOLLOWING LOCATIONS
•Location where there are inverter lighting equipment or electronic spontaneous lighting equip- ment
The remote control may become inoperative. In this case, move away from such lighting equipment or change direction.
•Location exposed to direct sunlight
The unit may not received signals from the remote control
The unit may not respond to the signals of the remote control if the ends of fluorescent lighting become black or lights flicker due the depletion of service life; however, this is not a malfunction of the remote control or the main unit. In this case, replace the lighting with new fluorescent tubes.
TAKE CAUTION TO THE FOLLOWING DURING INSTALLATION
•Leave at least 2m of space from televisions and radios Electrical interference may occur as a result.
•Leave at least 60cm of space from the wall
The motor may overheat, causing malfunction as a result.
•Avoid a location where sensors are exposed to direct wind The unit may not operate properly.
•Avoid a location where curtains, etc., come into contact with the intake or exhaust port. Curtains, etc., may become dirty or malfunction may occur as a result.
EFFECTIVE USAGE
•Stable surface with sufficient air circulation
•Near smoking area
Air pollution is detected quickly.
ABOUT THE FILTER
•Do not wash and reuse Apatite HEPA filter and deodorization filter. It doesn’t have effect, and they become an electric shock and the cause of the trouble.
•Small dust and odors such as tobacco smoke rise and accumulate at the top of the room.
•Large dust such as pollen and house dust accumulate at the bottom of the room.
•The wall, etc., behind the exhaust port may become dirty as time passes. When using the unit for extensive period in the same location, use a vinyl sheet, etc., to prevent the wall from becoming dirty. In addition, periodical clean the wall, etc.
ENGLISH
