Sharp FU-W53J operation manual Plasmacluster ON/OFF Button, Lights Control Button

With the unit OFF, press the Fan Speed Button for 3 seconds.

The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is Standard, indicated by the MED light.

Plasmacluster Indicator Light

CLEAN - SIGN Light

POWER ON/OFF Button

LIGHT CONTROL Button

ION SHOWER Mode Button

Plasmacluster ON/OFF Button

Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion Mode ON and OFF.

When Plasmacluster is ON, both the Indicator Light and Plasmaclus- ter Indicator will turn on.

LIGHTS CONTROL Button

ENGLISH

Turns the Plasmacluster Indicator Light and CLEAN-SIGN Light brighter, darker or off.

Refer to the diagram on the right to select the desired brightness of the Plasmacluster Indicator Light and CLEAN-SIGN Light.

｢	｣	The lights are brighter.
｢	｣	The lights are darker.
｢	｣	The lights turn off.

CAUTION

The lights on the front monitor are always brighter when starting.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to “low” if CLEAN-SIGN Light is constantly red to reduce sensitivity, and set to “high” if CLEAN-SIGN Light is constantly green to increase sensitivity.

1

2 Press the Fan Speed Button to set the desired sensor sensitivity.

Refer to the diagram on the right to select the desired sensor sensitivity level.

Fan Speed	Sensor Detection
Indicator Light	sensitivity
	High
	Standard
	Low

3 Press the Power ON/OFF Button.

Note that if the Power ON/OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the set- ting will be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged.

E-9