Connecting other equipment
The connection lead is not included. Purchase a commercially available lead as shown below.
■Connecting a guitar / microphone
Caution:
Be careful not to connect a bass guitar as it might damage this unit.
■Listening to the playback sounds of portable audio player, etc.
Microphone or guitar (not supplied)
Headphone (not supplied)
Portable audio player, etc.
?6.3 mm monaural cable (not supplied)
1Set the guitar/microphone volume (GAIN) knob to the minimum level.
2Connect a guitar/microphone to the correct input socket. Make sure that the cable has a 6.3 mm (1/4") diameter plug.
3Arrange the guitar/microphone cables into the grooves of the cable holder on the left or the right side of the unit. Then, thread the cable through the bottom of the unit.
Do not let the cables to be on top of the unit when using guitar/microphone as it may cause the unit to roll over causing damage and injury.
Thread the cables under the unit
Cable holder
4Connect the cables to a guitar/microphone.
5Select a source.
●To mix a guitar or microphone sound with a source sound, select the playback source (iPod/CD/USB/ Audio In/Tuner).
●To play a guitar or using the microphone only, select ’AUDIO IN’ function. Make sure there is no playback from Audio In connection.
6Adjust the volume (GAIN) knob on the connected equipment.
Audio cable (not supplied)
1Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket. When using video equipment, connect the audio output to this unit and the video output to a television.
2Press the
3Press the AUDIO IN button on the remote control or TUNER/AUDIO IN button repeatedly on the main unit to select AUDIO IN function.
4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the television.
■Headphones
●Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.
●Before plugging in or unplugging the headphone, reduce the volume.
●Be sure your headphone has a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.
●Plugging in the headphone disconnects the speakers automatically. Adjust the volume using the VOLUME control.
Note:
Before disconnecting the guitar/microphone, set the guitar/ microphone volume (GAIN) knob to the minimum level.
E-18
EN
12/10/26
