System preparation (continued)
■Fixing wall mount angle
1 Fix the pattern paper to the wall in horizontal position as below.
■ Installing the sound bar |
1 Align the wall mount slot at the sound bar to the |
wall mount angle. |
523 mm
Wall surface 30 mm
30 mm
2 | Slot the sound bar into the wall mount angle. |
3 | Fix them securely. |
Wall surface
Pattern paper
2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.
32 mm
Wall surface
3Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the wall surface.
32 mm
Wall surface
4Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 4 pieces)
Wall mount angle
Wall mount |
|
|
angle | Wall | Wall |
| ||
(screws x 2) | surface | mount |
|
| angle |
Wall surface |
|
|
(screws x 2) |
|
|
Wall surface |
|
Note:
Make sure all screws are fully tightened. (screws are not supplied)
Falling prevention
Safety wires (not supplied) are useful to prevent the sound bar from falling off the table.
L
R L
R
Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand.