SPECIFICATIONS
Model |
|
| |||
Power supply |
|
| |||
Power consumption (W) | (High) | 14.0 |
| (Low) | 6.5 |
Operating noise level (dBA) | (High) | 44 |
| (Low) | 34 |
Airflow volume(m3/hour) | (High) | 102 |
| (Low) | 72 |
Applicable floor surface area (m2)* |
| 10 |
|
| |
Power cord (m) |
| 1.8 |
|
| |
Outer dimensions (mm) |
| 140 160 345 (W | D | H) | |
Weight (kg) |
| 2.5 |
|
| |
|
|
|
|
|
|
*The target floor surface area, for which an emitted airborne ion density is of about 25,000 ions/cm3, can be measured at a point near the center of the room (at a height of about 1.2 m from the floor), during operation at the HIGH mode when the main unit is placed near a wall.
• The number of ions will vary according to the room conditions and the the main unit operation mode.
TROUBLESHOOTING
Before calling for service, please review the TROUBLESHOOTING chart below, since the problem may not be a Plasmacluster Ion Generator malfunction.
Problem
The Plasmacluster Ion Generator does not work.
flashing faster (red)
flashing (red)
flashing (blue)
flashing (blue)
WHAT TO DO
Make sure the unit is plugged in.
Approx. 2 years and 2 months (approx. 19,000 hours) has been passed.
Replace with a new Plasmacluster Ion Generating Unit. See page
Plasmacluster Ions are not released. Press the Operation button and restart.
If all lights keep flashing, replace with new Plasmacluster Ion Generating Unit. See page
•Dust may block the filter, clean the filter.
Failure
Unplug and contact the store you purchased or Sharp Service Center.
flashing (blue)
The discharged air has odor. |
| The Plasmacluster Ion Generator releases a |
|
| small trace of ozone which may produce odor. |
|
| This is not harmful to health. |
|
|
|
A clicking or ticking sound comes |
| Loudness can be changed depending on a room |
| ||
from the unit while operating the |
| humidity, but the effectiveness is the same. |
Plasmacluster Ion Generator. |
| Relocate the Plasmacluster Ion Generator if |
|
| necessary. |
|
| |
|
|
