INSTALLATION MANUAL
UNPACKING YOUR MICROWAVE DRAWER
To reduce the risk of tipping, the Microwave Drawer must be secured by a properly installed
Remove all packing materials from inside the Microwave Drawer.
DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the top of the Microwave Drawer.
Sealing
Surface 
Waveguide
Cover
block.
•This Microwave Drawer must be electrically grounded in accordance with local codes.
•Make sure the wall coverings and the cabinets around the Microwave Drawer can withstand the heat generated by the Microwave Drawer.
Never leave children alone or unattended in
Remove the feature sticker, if there is one. Check the drawer for
any damage, such as misaligned or bent
d r awe r, d a m a g e d
drawer seals and sealing surfaces, broken or loose Microwave Drawer guides and dents inside the cavity or on the front side of the drawer. If there is any damage, do not operate the Microwave Drawer and contact your dealer or a SHARP AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE INSTALLER
Read all of the Installation Manual before installing the Microwave Drawer.
•Remove all packing material before connecting the electrical supply
•Observe all governing codes and ordinances.
•Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Operation Manual for future reference.
•As when using any microwave oven generating heat, there are certain safety precautions you should follow. These are listed in the Operation Manual. Read all and follow carefully.
•Be sure your Microwave Drawer is installed and grounded properly by a qualified installer or service technician.
IMPORTANT SAFETY INSTRUCTIONS
If the information in this manual is not followed exactly, a fire or electrical shock may result that could cause property damage, personal injury or death.
the area where a Microwave Drawer is in use. Never leave the drawer open when the microwave is unattended.
Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause damage to the Microwave Drawer.
Do not use the Microwave Drawer as a storage space.
This creates a potentially hazardous situation
•Check that the
CLEARANCES AND DIMENSIONS
Dimensions that are shown in Figures 1 and 2 must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper
Contact surface must be solid and level. Pay special attention to the floor on which the Microwave Drawer will sit. The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 pounds).
Check location where the Microwave Drawer will be installed for proper electrical supply.
Your oven can be built into a cabinet or wall by itself or under a specific electric wall oven listed below.
Electrolux E30EW75DSS1
Kitchen Aid | KEBC107KBLO |
Frigidaire PLEB30S8CCC
Viking DES0100
WolfS030F/S
Be sure that the clearance of the floor between the wall oven and the microwave drawer is a minimum of
For updates of approved appliances that can be used adjacent to the Microwave Drawer go to www.sharpusa.com.
The microwave interior will easily accommodate a 9” x 13” oblong dish or a bag of microwave popcorn.
2