PREPARE THE HOOD

1Remove 7” Round Duct Plate from top of hood. Set duct plate aside - with mounting screws.

2 R e m o v e t a p e holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside.

3Remove Teflon®-

Coated Bottom Cover from hood. S e t c ove r a n d mounting screws aside.

Teflon® is a registered trademark of DuPont.

TEFLON®-COATED BOTTOM COVER

NON-DUCTED INSTALLATION - Skip to page 8.

The following Steps (6 thru 14) are for DUCTED INSTALLATION ONLY.

6 Remove Light Panel - held in place with (5) #8 screws.Disconnect light assembly w i r e h a r n e s s (white connector).

7Remove Air Chute - held in place with one (1) screw.

Note: Be careful not to disconnect any wires.

8Remove Baffle from air chute.

4 Remove Damper/

Duct Connector from inside the hood. Set connector aside-withmounting screws and parts bag.

(Held in place with 2 screws)

9

Rotate baffle.

 

Reinsert

baffle

 

into air

chute

DAMPER/ DUCT CONNECTOR

5 Remove either top or back wi r ing knockout and install approved Electrical Cable Clamp.

ELECTRICAL CABLE CLAMP

(as shown) so

that baffle

Tabs

fit all the

way

into Slots in air

chute. An audible

“click” will be

heard when fully

installed.

This

will close off the

air flow through

the non-ducted

slots on top of

hood.

 

6