Sharp LC-13S1M, LC15S1M Changing the Channels, To select a one-digit channel e.g., Channel

BASIC OPERATION (Continued)

Changing the Channels

Changing channels using CHANNEL SELECT on the remote control.

•To handle the increasing number of channels available, this LCD TV set allows you to select up to 100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow the procedure shown below to select channels.

BRIGHTWIDE		TEXT
POWER		TV/ ROTATEVIDEO
		T
HOLD	SUBPAGE	R
	SUBPAGE
HOLD		EVEAL
SUBTITLE		END
SUBTITLE		END
		E
SOUNDMPX	MENU	MENUOK
		M
VOL	CH

CH ( )/

( )

To select a one-digit channel (e.g., Channel 5):

1 Press the button.

2 If “5-” is indicated and the picture does not change, press the -/--button to switch over to the 1-digit

select mode and press again.

B / G

TV/VIDEO

SLEEP DIS.MODE

CHANNEL SELECT

A(Flash- back)

To select a two-digit channel (e.g., Channel 15):

1 Press the -/--button to set the 2-digit select mode.

2 Press the button.

3 Press the button.

Note:

•Complete this procedure within 4 seconds, otherwise the selection will not be made.

•Press A (Flashback) to show the previous channel.

B / G

Changing channels with CH ( )/( ) on the remote control.

Press CH ( ) and the channels change in the order shown below: 1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .

Press CH ( ) and the channels change in the order shown below: 3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .

14