
Connecting a PC
Viewing an Image from a PC
Use the INPUT5
A
•The PC input terminals are
•Refer to page 35 for a list of PC signals compatible with the System.
•Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with the PC. (See pages 34 and 35.)
•Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your PC’s manuals regarding converting to external output.
To AUDIO | To Audio output |
input terminal | terminal |
ø 3.5 mm stereo minijack cable
(commercially available)
RGB cable (supplied)
To ANALOG | To ANALOG RGB | PC |
| ||
RGB terminal | output terminal |
|
Connecting the RGB cable
Ferrite core • Connect the RGB cable making sure that it fits correctly into the terminal.
Then, firmly secure the connectors
by tightening the screws on both
sides of the plug.
• Do not remove ferrite cores attached to the RGB cable.
Signal names for
5 | 4 | 3 | 2 | 1 |
10 | 9 | 8 | 7 | 6 |
15 | 14 | 13 | 12 | 11 |
Pin No. | Signal name | Pin No. | Signal name | Pin No. | Signal name |
1 | R | 6 | GND (Ground) | q | Not connected |
2 | G | 7 | GND (Ground) | w | SDA |
3 | B | 8 | GND (Ground) | e | HD |
4 | Not connected | 9 | +5V | r | VD |
5 | CSYNC | 0 | GND (Ground) | t | SCL |
A
•Pin No. 5 is not used for inputting the signal.
•Pin No. 9 is not connected with the supplied RGB cable.
Displaying an Image from a PC
To view an image from a PC, perform the following procedure.
1 Select the INPUT5 (PC) mode using INPUT on the remote control or the LCD TV set. (See page 16.)
2 Select the PC input signal. (See page 34.)
3Select the PC sound input mode. (See page 23.)
4 Adjust the “FINE SYNC.” items if the PC image does not come in clearly. (See page 34.)
33