Sharp LC-32DV28UT operation manual Displaying an image from a PC, PC compatibility chart

Connecting to External Equipment

■ When using DVI-HDMI conversion cable (INPUT 4):

Rear of the TV

6

DVI-HDMI conversion cable

3

2

1

DVI OUT AUDIO

(Illustration is LC-26DV28UT.) Ø 3.5 mm stereo minijack cable

NOTE

•When using an DVI-HDMI conversion cable, you should make an analog audio connection. In this case, in addition to connecting an DVI-HDMI conversion cable to the INPUT 4 (HDMI1) terminal, connect an audio cable to the AUDIO PC/ HDMI terminal and set “HDMI1 Audio” to “DVI”. (See page 28.)

■ When using analog RGB cable (INPUT 6):

Analog RGB cable	Rear of the TV
(D-sub 15pin cable
or VGA cable)

	Ø 3.5 mm stereo
RGB AUDIO
	minijack cable

6

3

2

1

(Illustration is LC-26DV28UT.)

NOTE

• When using an analog RGB cable, input the audio signal to the AUDIO PC/HDMI terminal of INPUT 6.

Displaying an image from a PC

To view an image from a PC, perform the following procedure.

①Select the Input 6 (PC) mode using INPUT on the remote control or the TV/DVD set. (See page 15.)

② Adjust the “Picture” items if the PC image does not come in clearly. (See page 28.)

PC compatibility chart

PC	Resolution		Horizontal	Vertical	VESA
			Frequency	Frequency	Standard
		720 x 400	31.5 kHz	70 Hz	-
	VGA		31.5 kHz	60 Hz	○
		640 x 480	37.9 kHz	72 Hz	○
			37.5 kHz	75 Hz	○
			35.1 kHz	56 Hz	○
PC	SVGA	800 x 600	37.9 kHz	60 Hz	○
			48.1 kHz	72 Hz	○
			46.9 kHz	75 Hz	○
	XGA	1,024 x 768	48.4 kHz	60 Hz	○
			56.5 kHz	70 Hz	○
			60.0 kHz	75 Hz	○
	WXGA	1,280 x 768	47.8 kHz	60 Hz	○
		1,360 x 768	47.7 kHz	60 Hz	○

19