Menu operations
Power Control menu
MENU [Power Control]
Audio | Power Control |
No Signal Off | [Disable] |
No Operation Off | [Disable] |
|
|
No Signal Off | TV/AV only |
|
|
Menu Operation: A (page 12)
When set to “Enable” the TV will automatically enter the standby mode if there is no signal input for 15 minutes.
•Five minutes before the TV enters standby mode, the remaining time displays every minute.
NOTE
•When a TV programme finishes, this function may not operate.
•This function is not available in DTV mode.
No Operation Off | TV/DTV/AV only |
|
|
Menu Operation: A (page 12)
When set to “Enable” the TV will automatically enter the standby mode if no operations are performed for 3 hours.
•Five minutes before the TV enters standby mode, the remaining time displays every minute.
Power Management | PC only |
|
|
Menu Operation: A (page 12)
When set, the TV will automatically enter the standby mode.
Item
Off: • No power management
• Factory preset value.
Mode1: • If there is no signal input for 8 minutes, the TV enters the standby mode.
•Even if you start using the PC and the signal inputs again, the TV stays in standby mode.
•The TV turns on again by pressing a on the
TV or Bon the remote control unit. (See page 8.)
Mode2: • If there is no signal input for 8 seconds, the TV enters the standby mode.
•When you start using the PC and the signal inputs again, the TV turns on.
•The TV turns on again by pressing a on the TV or B on the remote control unit. (See page 8.)
Setup menu
MENU [Setup]
Setup | Option |
Auto Installation |
|
Programme Setup |
|
Child Lock |
|
Position |
|
WSS | [On] |
4:3 Mode | [Panorama] |
Language | [English] |
Supply Voltage | [Off (0V)] |
|
|
Auto Installation | TV only |
|
|
Programme Setup | TV only |
|
|
This section describes how to set up analogue TV channels manually.
1
2
3 Press a/b to select “Programme Setup”, and then press OK.
If you have already set the PIN under “Child Lock”, enter it here.
• See page 17 for setting PIN.
4 Press a/b to select “Auto Search”, “Manual Adjust”, “Sort” or “Erase Programme”, and then press OK.
Auto Search |
|
Manual Adjust |
|
Sort |
|
Erase Programme |
|
No | Yes |
Auto Search
You can automatically search for and download TV channels by performing the procedure below. This is the same function as from programme auto search to preset download in Auto Installation.
1 Repeat steps 1 to 4 in Programme Setup.
2 Press c/dto select “Yes”, and then press OK.
1Programme auto search
2Auto labelling
3Auto sorting
4Preset download
15
