Sharp LC-40D68UT operation manual CH Setup, Position, PC Setup, Input Skip, Input Label

On-Screen Display Menu

CH Setup

If Initial Installation does not memorize all the channels in your region, follow the instructions below to manually memorize the channels.

Air/Cable: Make sure what kind of connection is made with your TV when selecting "Air" or "Cable".

CH Search: Channel auto search makes the TV look for all channels viewable in the set area.

CH Memory: You can select the channels to skip in each ANALOG (Air), ANALOG (Cable), DIGITAL (Air) and DIGITAL (Cable).

On: Skips channels. (Channel selection disabled using CH r/s.)

Off: Does not skip channels. (Channel selection enabled using CHr/s.)

Antenna Setup Digital: In order to receive digital air broadcasts, you need a digital broadcast antenna. You can confi rm the antenna confi guration through the "Antenna Setup Digital" screen. If necessary, adjust the direction of the antenna to obtain the maximum signal strength.

Signal Strength: The signal strength of DIGITAL channel is displayed. The signal information is based on the current channel.

Channel Strength: Input the 2-digit channel number to check the signal strength of the selected channel. Make sure the signal is strong enough for each channel.

•This function is available for DIGITAL (Air) only.

•See Initial Installation on page 12 for setting each item.

•If no channel is found, confi rm the type of connection made with your TV and try channel search again.

Position

For adjusting a picture's horizontal and vertical position.

H-Pos.:Centers the image by moving it to the left or right.

V-Pos.:Centers the image by moving it up or down.

•For resetting adjustments to the factory preset values, press a/b to select "Reset", and then press ENTER.

•When connecting a PC to the HDMI terminal, the image position will be automatically adjusted. It cannot be manually adjusted.

•Adjustments are stored separately according to input source.

•When a DTV channel is selected, the horizontal position cannot be adjusted.

•The horizontal and/or vertical position may not be able to be adjusted or it may be adjusted only to a certain degree.

PC Setup

Input Signal (for Analog PC Input Mode Only)

Some input signals may have to be registered manually to display properly. The pair of input signals (resolutions) in the list below is not distinguishable when received.

In such a case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.

1024 x 768 1360 x 768

Input Skip

This setting allows you to skip the HDMI or PC-IN Input ("INPUT4 (PC)", "INPUT5 (HDMI)", "INPUT6 (HDMI)" and "INPUT7 (HDMI)") on the Input Selection operation.

Yes: Skips the input.

No: Does not skip input.

Input Label

Lets you set the input terminal displayed when using the INPUT SOURCE menu or channel display. Press a/b/c/d to select the new name for the input mode.

• You cannot change labels if the INPUT SOURCE is TV.

•You can only select the "Input Signal" on the Setup menu when receiving one of the 2 input signals listed above.

Auto Sync. (for Analog PC Input Mode Only)

For automatically adjusting the PC image.

Yes: Auto Sync. starts.

No: This function does not work.

•When "Auto Sync." is successful, "Completed" displays. If not, "Auto Sync." failed.

•"Auto Sync." may fail even if "Completed" displays.

•"Auto Sync." may fail if the computer image has low resolution, has unclear (black) edges, or is moved while executing "Auto Sync.".

•Be sure to connect the PC to the TV and switch it on before starting "Auto Sync.".

20