Sharp LC0760, LC1460, LC1060 manual Pre-Operatinginstructions, Operating Instructions

5.Indicator Lights – Indicator lights tell the user when the unit is on, (“Power” symbol), and when the unit's mode is set to have ions emitted, (“Ions” symbol).

6.Filter Condition Monitor – When the ball, at high speed setting, reaches the high end of the indicator scale, the filter cartridge is loaded with particulate pollutants and needs changing (LC0760 & LC1060).

7.Fan Control – The air-cleaning rate of the unit can be controlled for maximum efficiency and convenience. The two speed fan control is used to select the operating speed of the fan. The unit is designed to run continuously at the low speed setting. For extended motor life, it is recommend- ed that the high speed setting be used only when necessary.

8.Filter Check Light (LC1460) – An electric switch senses the condition of the filter cartridge and turns on an indicator light if the filter cartridge needs to be changed.

PRE-OPERATING INSTRUCTIONS

1.When removing the unit from the packing case, visually check for shipping damage. Please contact both the shipper and your dealer immediately if the unit bears any sign of damage from mishandling. All Bionaire® units are carefully inspected before leaving our factory.

2.KEEP SHIPPING CARTON AND PACKING for use in the unlikely event that your Bionaire® unit needs servicing. If this unit is shipped without the original packing, damage could occur and void the warranty.

3.PLEASE REFER TO THE FOLLOWING PROCEDURE BEFORE OPERATING YOUR NEW Bionaire® Air Cleaner.

WARNING: Check the operating voltage shown on the back of the unit. Do not operate at voltages other than shown.

OPERATING INSTRUCTIONS

1.Remove the inlet grill, remove the HEPA filter cartridge and the carbon filter and remove any plastic wrapping or panels from them. Re-install the filters as per the section “Filter Replacement”.

2.After re-installing the filters, choose a suitable location, table top, shelf or wall (see wall-mount instructions) ensuring that both the air intake and exit are not obstructed. The air cleaner can be placed as a vertical “tall” unit, or

5