QUICK REFERENCE

Attaching/Detaching the Stand

•Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Attach the stand in the correct direction.

•Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

1Confi rm that there are 9 screws supplied with the stand unit.

2Attach the supporting post for the stand unit onto the base using the box for the stand unit as shown

Setting the TV on the Wall

CAUTION

•This TV should be mounted on the wall with both the AN-37AG2 (SHARP) wall mount bracket and the AN-37P30 (SHARP) attachment of the wall mount bracket. The TV cannot be mounted when with only the AN-37AG2 wall mount bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.

•Installing the TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.

Using an optional bracket to mount the TV

• You can ask a qualifi ed service professional about

using an optional AN-37AG2 bracket to mount the TV

to the wall.

• Carefully read the instructions that come with the

below.

2

Screws

3 Hex key

1

bracket before beginning work.

Hanging on the wall

AN-37AG2 wall mount bracket.

(See the bracket instructions for details.)

Vertical mounting

Angular mounting

31 Insert the stand into the openings on the bottom of the TV.

2 Insert and tighten the 4 screws into the 4 holes on the rear of the TV.

Hex key 2

Screws

Soft cushion

1

• To detach the stand, perform the steps in reverse order.

About setting the TV angle

LC-32D64U

• The center of the display: 11/16 inch (17.3 mm) under the “A” position.

LC-37D64U

• The center of the display: 1 3/4 inch (44.1 mm) under the “A” position.

• Refer to the operation manual of AN-37P30 for details.

•Detach the cable clamp on the rear of the TV when using the optional mount bracket.

•Due to the terminal confi guration on this TV, when you wall-mount this model, make sure there is enough space between the wall and the TV for the cables.

•To use this TV mounted on a wall, fi rst remove the adhesive tape at the 4 locations on the rear of the TV, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the TV.

5