133
TROUBLESHOOTING AND MAINTENANCE
5
MISFEED IN THE UPPER EXIT AREA
(
when a job separator tray kit or finisher (MX-FN13) is installed
)
If a job separator tray kit or a finisher is installed, a misfeed may occu r in the upper exit area.
1Open the upper right side cover. 2Gently pull the misfed paper out.
Be careful not to tear the
misfed paper during
removal.
3Close the upper right side cover.
Make sure that the misfeed message is cleared.
MISFEED IN AN OUTPUT TRAY
(when a finisher (MX-FN13) is installed)
1Open the cover.
2While pressing the lever over to the
left, slide the finisher to the left until it
stops.
Gently slide the finisher
until it stops.
3Turn roller rotating knob in the
direction of the arrow to remove the
misfed paper.
4Slide the finisher back to the right.
5Close the cover.