Sharp PG-D40W3D quick start Setting a Password

Setting up the Projector Network Environment (“Network” Menu)

Menu operation n Page 38

		Pict. SCR		PRJ		Network		Help
1		Password					Disable
2		DHCP Client					Off
3		TCP/IP
			MAC Address	XX : XX : XX : XX : XX : XX
4
			Projector	XX-XXXX
			SEL./ADJ.		ENTER			END
	1 Setting a Password						Enter the password in “Old
						2
							Password” using P, R, Q and O,
If you do not want others to change the setting
							then press ENTER.
for the “Network” menu, set a password.

a Setting a Password

1 Select “Password”, then press ENTER or Q.

•The screen for entering the password appears.

	Network
Setting the Password
Old Password		– – – –
New Password		–	–	–	–
Reconfirm		– – – –

2 Press P or R to set the first digit

in “New Password”, then press Q.

3 Enter the remaining 3 digits, then press ENTER.

• To return to the previous digit, press O.

4 Enter the same password in “Reconfirm”, then press ENTER.

•The status for “Password” changes to “Enable”.

Note

•Once the password is set, you must enter the password to change the “Network” menu settings.

a Changing the Password

1 Select “Password”, then press ENTER or Q.

3 Enter the password in “New Password” using P, R, Q and O, then press ENTER.

4 Enter the same password again in “Reconfirm” using P, R, Q and O, then press ENTER.

Note

•If you do not need the password protection for the “Network” menu settings anymore, press ENTER without entering the new password in steps 3 and 4.

•To cancel the password settings, press

RETURN.

If you forget the password

If you forget the password, perform the following procedure to delete it, then set a new password.

On the projector, press

.

Note

•If ENTER is held down for more than 5 seconds, the operation buttons on the projector will be locked. (See page 48.)

•You cannot use the buttons on the remote control to delete the password.

Features Useful

• The screen for entering the password appears.

49