Sharp PG-LS2000 appendix Turn the computer on 8. Turn the power off, PG-LX2000 only, Easy Start

BP. 26

6. Select the Input mode

Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode.

On the remote control

Shrinks

lower side.

Shrinks

upper side.

(When “Setup Guide” is set to “On”. See page 45.)

2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.

BP. 24

5. Correct trapezoidal distortion

Correcting trapezoidal distortion using Keystone Correction.

After the projector turns on, the Setup Guide appears.

1

4. Adjust the projected image with the Setup Guide

Easy Start

On the	On the remote	INPUT list (e.g. PG-LX2000)
projector	control
		INPUT	Audio

COMPUTER

HHDMI

VVIDEO

[PG-LX2000 only]

When you select HDMI input, use O/Q to select the audio input terminal (HDMI or AUDIO).

BP. 27

7.Turn the computer on

8.Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confi rmation message is displayed to put the projector into Standby mode.

On-screen display

On the	On the remote
projector	control

BP. 23

15