Sharp PN-T321 operation manual Safety Precautions

SAFETY PRECAUTIONS (Continued)

19. Batteries — Incorrect use of batteries may cause the batteries to burst or ignite. A leaky battery may corrode the equipment, dirty your hands or spoil your clothing. In order to avoid these problems, make sure to observe the precautions below:

•Install the batteries with due attention to the plus (+) and minus (-) sides of the batteries according to the instructions in the compartment.

•Replace an exhausted battery with a new one promptly.

•Do not short the terminals.

•Do not throw into water or fire. Do not disassemble.

•Use the specified batteries only.

•If you will not use the remote control for a long time, remove the batteries.

•If leaked battery fluid gets on your skin or clothing, rinse immediately and thoroughly. If it gets into your eye, bathe your eye well rather than rubbing and seek medical treatment immediately. Leaked battery fluid that gets into your eye or your clothing may cause a skin irritation or damage your eye.

Store lithium batteries outside the reach of small children. In the event that a battery is swallowed, seek the advice of a physician immediately.

20. Usage of the monitor must not be accompanied by fatal risks or dangers that, could lead directly to death, personal injury, severe physical damage or other loss, including nuclear reaction control in nuclear facility, medical life support system, and missile launch control in a weapon system.

21. Do not stay in contact with the parts of the product that become hot for long periods of time. Doing so may result in low-temperature burns.

WARNING:

This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate counter measures.

To maintain compliance with EMC regulations, use shielded cables to connect to the following terminals: PC/AV DVI-D input terminal, PC/AV HDMI input terminal, PC D-sub input terminal, AV COMPONENT input terminal, AV video/AV audio input terminal, and RS-232C input terminal.

If a monitor is not positioned in a sufficiently stable location, it can be potentially hazardous due to falling. Many injuries, particularly to children, can be avoided by taking simple precautions such as:

•Using fixing devices like wall mount brackets recommended by the manufacturer.

•Only using furniture that can safely support the monitor.

•Ensuring the monitor is not overhanging the edge of the supporting furniture.

•Not placing the monitor on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the monitor to a suitable support.

•Not standing the monitors on cloth or other materials placed between the monitor and supporting furniture.

•Educating children about the dangers of climbing on furniture to reach the monitor or its controls.

Especially for child safety

-Don’t allow children to climb on or play with the monitor.

-Don’t place the monitor on furniture that can easily be used as steps, such as a chest of drawers.

-Remember that children can become excited while watching a program, especially on a “larger than life” monitor. Care should be taken to place or install the monitor where it cannot be pushed, pulled over, or knocked down.

-Care should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by curious children.

3 E