Sharp R-297F operation manual Installation Instructions, Oven Diagram, A38577,Russia R297F O/M,RU

A38577,Russia R297F O/M,RU

INSTALLATION INSTRUCTIONS

1.Remove all packing materials from the oven cavity . Check the unit for any damage, such as a misaligned door, damaged gaskets around the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.

2.Accessories provided

1)Turntable tray

2)Roller stay

3)Operation manual

4)2 Cook books

3.Locate the roller stay in the centre of the oven, then fit the turntable on the roller stay. Make sure the turntable and roller stay are centrally located and locked together. NEVER OPERATE THE OVEN WITHOUT THE ROLLER STAY AND TURNTABLE.

4.The oven should not be installed in any area where excessive heat and steam are generated, for example, next to a conventional oven unit. The oven should be installed so as not to block ventilation openings.

Allow at least 15 cm on the top of the oven for free air space.

5.Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury for failure to observe the correct electrical connecting procedure.

The A.C. voltage must be single phase 220V, 50Hz.

OVEN DIAGRAM

6		2		w
		9
		e
3		8
		1
4 5	7	0 4
		r	q	t

1. Door open button	8. Control panel (See page E-4)
2. Oven lamp	9. Liquid crystal display
3. Door hinges	10. Waveguide cover (Do not remove)
4. Door safety latches	11. Power supply cord
5. See through door	12. Ventilation openings
6. Door seals and sealing surfaces	13. Turntable
7. Coupling	14. Roller stay
	15. Rating plate

E – 3

Russia R297F,En,P01-03 3 03.10.23, 3:28 PM