21
SD-EX200
03/3/14 SD-EX200_sec.fm TINSZ0523AWZZ
2
3
4
5
6
7
8
1
Radio
- Listening to the radio -
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
z"" will appear when an FM broadcast is in stereo.
zIf the FM reception is weak, press the TUNER (BAND) button to extinguish the
"ST" indicator. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Memorizing a stati o n
You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
Note:
The backup function protects the memorized stations for a fe w hours should there be
a power failure or if the AC power cord is disconnected.
To recall a memorized station
This may be operated only with the remote control.
FM stereo mode indicator
FM stereo receiving indicator
1Perform steps 1 - 3 in "Manual or Auto tuning" on page 20.
2Press the ENTER button to enter the preset tuning saving mode.
3Within 5 seconds, press the TUNER
PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4Within 5 seconds, press the ENTER
button to store that station in mem o-
ry.
If the preset number indicator goes out before the station is memorized, repeat
the operation from step 2.
5Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorized will
be erased.
To select a preset station with the TUNER PRESET buttons:
Press the TUNER PRESET ( or ) button to select the desired station.
To select a preset s tation wi th the direct buttons:
Station 1 - 10: press the corresponding number ("1" - "10/0").
Station 11 - 40: press the " 10" button followed by the two-digit number.
For example, to choose 28
1Press the " 10" button.
2Press the "2" button.
3Press the "8" button.
Preset channel Frequency and frequency band