E-19
SD_HX600_SEC_SECL_E1.fm04/3/15
ENGLISH
TINSKA016AWZZ
SD-HX600
Preparation for Use
- Setting the clock -
Setting the clock
By setting the unit to the correct time, you can use it not only as a clock but also for
timer playback.
In this example, the clock is set to 9:30 AM.
To confirm the time display:
[When the unit is in the stand-by mode]
Set the MODE 1/MODE 2 switch to MODE 1 and press the DISPLAY button.
The time display will appear for about 5 seconds.
[When the power is on]
Set the MODE 1/MODE 2 switch to MODE 2 and press the TIMER/SLEEP button.
Within 10 seconds, press the or button to select "CLOCK".
The time display will appear for about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from the beginning.
"In step 2, the time will be displayed.
"Follow steps 3 - 4.
Note:
Unplugging the unit or power failure will clear the clock setting.
Readjust the clock.
1Turn on the power, set the MODE 1/MODE 2 switch to MODE 2 and
press the TIMER/SLEEP button.
2Within 10 seconds, press the or
button to select "CLOCK ADJUST",
and then press the ENTER button.
3Press the or button to adjust the
hour and then press the ENTER but-
ton.
"Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
"The 12-hour display will appear.
""AM" will change to "PM" automatically.
4Press the or button to adjust the
minutes and then press the ENTER
button.
"Press the or button once to advance the time by 1 minute. Hold it down
to advance continuously.
"The hour will not advance even if minutes advance from "59" to "00".
"The clock starts from "0" second (seconds are not displayed).
"The time disappears after approx. 2 seconds.