E-67
SD_HX600_SEC_SECL_E6.fm04/3/15
ENGLISH
TINSKA016AWZZ
SD-HX600
References
- Troubleshooting chart -
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.
!General
!Tuner
!AV selector
Symptom Possible cause Reference
page
No sound is heard. "Is the volume level set to "0"? P. 20
"Are the headphones connected? P. 65
"Are the speaker wires disconnect-
ed? P. 15
"Is the correct function selected for
the AV selector? P. 62
The sounds from speakers
are not well balanced.
"Are the speaker wires connected to
the wrong channels? P. 15
Noise is heard during play-
back.
"Move the unit away from any com-
puters or mobile phones.
When a button is pressed,
the unit does not respond.
"Set this unit to the power stand-by
mode and then turn it back on. If the
unit still malfunctions, reset it.
P. 69
Interference or noise occurs
on the TV image.
"Is the unit placed near TV with inter-
nal antenna? Use an outdoor anten-
na.
P. 16
Timer playback does not
start.
"Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock and timer.
P. 19, 53
"CLOCK ADJUST" appears
when checking the clock.
"Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock.
P. 19
The display on the unit is
dark.
"Is the display in the dimmer mode? P. 20
The power is not turned on. "Is the unit unplugged? P. 18
No images are displayed. "Is TV turned on? P. 56
"Is the input of TV switched? P. 56
"Is the correct function selected for
the AV selector? P. 62
Symptom Possible cause Reference
page
The radio makes unusual
noises continuously.
"Is the unit placed near the TV or
computer?
"Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near.
P. 16
The preset channel cannot
be recalled.
"Did you remove the plug from the
AC outlet, or did a power failure oc-
cur?
P. 38
Preset the channel again.
Symptom Possible cause Reference
page
No image appears on a TV,
or images from the source
equipment do not appear.
"Is the same function selected for the
main unit and AV selector? P. 22, 62
Image cannot be played
back. (Sound is not heard.)
"Is the same function selected for the
main unit and AV selector? P. 62
"Are the video and audio cables con-
nected improperly? P. 13, 61
"Is the AV selector turned on? P. 18
After recording, contents are
not recorded on DVD-R,
DVD-RW discs or video-
tapes.
"Are the source equipment and target
equipment connected properly? P. 61, 63
"Is the same function selected for the
main unit and AV selector? P. 62 - 64
"Is the correct channel selected for
the target equipment? P. 63
"Are you recording material with copy
protection? P. 62 - 64
"Is the source equipment connected
with a component video cable? P. 64
"Is the source equipment connected
with a digital audio cable? P. 64