INSTALLATION
1.To ensure adequate ventilation for your refrigerator, it is recommended to provide space of 6cm on both sides and at the back, and space of 9cm above the refrigerator. Insufficient spacing will decrease cooling efficiency, increase energy consumption and may reduce the life of the unit and void any warranty.
2.Using the two front adjustable feet, ensure that the refrigerator is positioned firmly and level on the floor.
5.Connect the power plug to a 230/240 volt. 10 amp. power point.
NOTE:
•Position your refrigerator so that the plug is accessible.
•Keep your refrigerator out of direct sunlight.
•Do not place next to heat generating appliance.
•This refrigerator is designed for indoor use only, do not place the unit on an unsealed surface.
•To avoid vibration and misalignment of the doors, the unit must be level. Place the unit on a solid flat surface. Uneven floors eg. slate, tiles and floorboards, can cause the unit to sag over time causing the doors to become misaligned.
•If the mains power is switched on when the door is open, the door alarm will sound. Close the door to stop the alarm.
Adjustable foot
3.Using the adjustable feet, raise the front of the unit so it leans back slightly, this will assist in door closing. Make final adjustments to ensure that the doors are correctly aligned.
When the left door is raised. When the right door is raised.
Lower the foot | Lower the foot |
at right side. | at left side. |
(Until the adjustable foot on the other side is slightly
4.Remove the 4 screws from the bottom of the refrigerator and use these to fit the foot cover (supplied inside the refrigerator compartment).
Screw
(4 Screws)
Screw
Foot cover
When transporting
•Using the casters, it is possible to move back and forth.
Casters
•Carry the refrigerator by holding the handles located on the rear and bottom.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water. If soapy water is used, wipe it off thoroughly.
3