Mini DV Cassette
Precautions when using a Mini DV cassette
•Be sure to use only Mini DV cassettes with the imark.
•This camcorder can record and play back using Mini DV cassettes with cassette memory, but it cannot record or play back this memory.
•To record in LP mode, use a Mini DV cassette labeled for use with LP mode.
•Do not insert anything into the holes on the bottom of the Mini DV cassette or block them in any way.
•Avoid placing the Mini DV cassette in an area conducive to dust or mold.
•Do not place the Mini DV cassette near magnetic sources such as electric clocks or magnetic devices as this may adversely affect recorded material.
•When a previously recorded Mini DV cassette is used again for recording, the previously recorded material will be automatically erased.
•The Mini DV cassette will not operate if inserted in the wrong direction.
•Do not repeatedly insert and eject the Mini DV cassette without running the tape as this may cause uneven tape winding and damage the tape.
•Do not place the Mini DV cassette in direct sunlight, near strong heat sources, or in areas with excessive steam.
•Store the Mini DV cassette in its case and stand it in an upright position.
•If the tape is not properly wound, rewind the tape.
•Do not drop the Mini DV cassette or subject it to excessive shocks.
To protect recordings against acciden- tal erasure
Slide the protect tab on the rear of the Mini DV cassette to the “SAVE” position.
Erasure protect tab
To record over a previously recorded tape, slide the protect tab to the “REC” position.
AC Adapter
•The AC adapter may interfere with reception if used near a radio.
•Prevent flammables, liquids, and metal objects from entering the adapter.
•The adapter is a sealed unit. Do not attempt to open or modify it.
•Do not damage, drop, or subject the adapter to vibration.
•Do not leave the adapter in direct sunlight.
•Avoid using the adapter in humid or ex- tremely hot places.
Replacing the Fluorescent Lamp
This camcorder uses a fluorescent lamp to backlight the LCD monitor. If the monitor becomes dark or difficult to view, the fluores- cent lamp may need to be replaced. Contact the nearest SHARP service center or your dealer for further advice.
Appendix
52
