GETTING STARTED
Please follow the procedure shown below.
1 | Installing the cash register |
Find a stable surface near an AC outlet where the cash register will not subject to water sources or direct sunlight .
Unpack the cash register and make sure all accessories are included. For details of accessories, please refer to “Specifications” section.
2 | Connecting the barcode scanner |
To scan barcodes, connect the included barcode scanner to the cash register.
1.Open the Serial/Scanner port cover at the right side of the register.
2.Insert the connector of the barcode scanner into the Serial/Scanner port, and tighten both of screws on the connector.
Always unplug the power cord of the cash register when you connect or disconnect the barcode scanner.
3 | Initializing the cash register |
In order for the cash register to operate properly, you must initialize it before operating for the first time. Follow this procedure.
1.Make sure the power cord plug is not inserted into the AC outlet.
2. | Insert the manager (MA) key into the mode switch and turn it to the PGM position. |
|
| REG | |||
|
|
|
|
| |||
|
|
|
| OPX/Z | MGR | ||
|
|
|
| OFF | X1/Z1 | ||
|
|
|
|
| |||
|
|
|
| VOID | X2/Z2 | ||
|
|
|
| PGM |
|
|
|
3. | While holding down both the }key and the lkey, insert the plug into the |
|
|
|
|
| |
|
|
|
| ||||
| *** MRS. *** | ||||||
| AC outlet. The buzzer will sound three times and “??? MRS. ???” will |
|
|
|
|
|
|
|
|
|
|
|
|
| |
4. | be displayed. |
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| ||
The cash register has now been initialized. The register display will now |
|
|
|
|
|
| |
|
|
| PGM | ||||
| show “0.00” with “PGM”. |
|
|
| 0.00 | ||
|
|
|
|
|
|
|
|
If the buzzer does not sound when the plug is inserted, the initialization has not been done successfully. (This will occur when the voltage is high because you operated the cash register before starting initialization.) Wait at least ten seconds after pulling out the plug and initialize the cash register again.
8