The cash register has a built-in memory protection circuit which is operated by rechargeable batteries. Since the rechargeable batteries have been discharged, please charge the batteries for one or two days before using the cash register for the first time. To charge the batteries, set the mode switch to a position other than “OFF” with the power cord plugged into the AC outlet. Unless the batteries have been charged, all of the programmed data and sales data is not saved.

If you press a key by mistake, an error message such as “HEAD UP” or “PAPER EMPTY” may be displayed. Press the lkey to clear message after installing paper rolls.

4

Preparing the cash register

To make the cash register ready for operation, remove the retainer and set the print head release lever in print position.

1.Push the printer cover forward and detach it.

2.Remove the white retainer at the position shown at the right. Please keep this retainer for future use when transferring the cash register.

3.Move the print head release lever to the printing position as illustrated at the right.

Retainer

Print head release lever (printing position)

5

Installing paper rolls

Precaution: The paper cutter is mounted on the printer (receipt side). Take caution when installing paper rolls.

The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal paper rolls) provided with the register.

Install the paper rolls according to the procedure shown below with the power cord connected and the mode switch set to the PGM position:

How to cut a paper roll and set it in the paper roll cradle:

 

 

To the printer

To the printer

Correct

Incorrect

Correct

Incorrect

1.Cut off approximately one revolution of each paper roll. Make sure each paper end is cut as illustrated above.

2.Set a paper roll in the paper roll cradle of the receipt side as illustrated above.

9