GETTING STARTED

Please follow the procedure shown below.

1

Installing the cash register

 

Find a stable surface near an AC outlet where the cash register will not subject to water sources or direct sunlight .

Unpack the cash register and make sure all accessories are included. For details of accessories, please refer to “Specifications” section.

2

Initializing the cash register

 

In order for the cash register to operate properly, you must initialize it before operating for the first time. Follow this procedure.

1.Make sure the power cord plug is not inserted into the AC outlet.

2.

Insert the manager (MA) key into the mode switch and turn it to the PGM position.

 

 

REG

 

 

 

 

OPX/Z

MGR

 

 

 

 

OFF

X1/Z1

 

 

 

 

 

 

 

 

 

VOID

X2/Z2

 

 

 

 

PGM

 

 

 

3.

While holding down both the }key and the lkey, insert the plug into

 

 

 

 

 

 

 

 

 

 

*** MRS. ***

 

the AC outlet. The buzzer will sound three times and “??? MRS. ???”

 

 

 

 

 

 

 

 

 

 

 

 

 

4.

will be displayed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The cash register has now been initialized. The register display will now

 

 

 

 

 

 

 

 

 

PGM

 

show “0.00” with “PGM”.

 

 

 

0.00

 

 

 

 

 

 

 

 

If the buzzer does not sound when the plug is inserted, the initialization has not been done successfully. (This will occur when the voltage is high because you operated the cash register before starting initialization.) Wait at least ten seconds after pulling out the plug and initialize the cash register again.

The cash register has a built-in memory protection circuit which is operated by rechargeable batteries. Since the rechargeable batteries have been discharged, please charge the batteries for one or two days before using the cash register for the first time. To charge the batteries, set the mode switch to a position other than “OFF” with the power cord plugged into the AC outlet. Unless the batteries have been charged, all of the programmed data and sales data is not saved.

If you press a key by mistake, an error message such as “HEAD UP” or “PAPER EMPTY” may be displayed. Press the lkey to clear message after installing paper rolls.

7