13
XL-E80

Basic Operation

Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 12-hour (AM 12:00) display. To confirm the time display:
Press the CLOCK button.
The time display will appear for about 7 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the "AM 12:00" is
not flashing in step 1, step 2 (for selecting the 12-hour or 24-hour
display) will be skipped.
To change the 12-hour or 24-hour display:
1Press the CLOCK button and within 7 seconds, press the
MEMORY button.
2Press the PRESET ( or ) button to select 12-hour or 24-
hour display and then press the MEMORY button.
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
3Press the PRESET ( or ) button to adjust the hour and
then press the MEMORY button.
"Press the PRESET ( or ) button once to advance the time
by 1 hour. Hold it down to advance continuously.
"When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
4Press the PRESET ( or ) button to adjust the minutes
and then press the MEMORY button.
"Press the PRESET ( or ) button once to advance the time
by 1 minute. Hold it down to advance continuously.
"The hour will not advance even if minutes advance from "59"
to "00".
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 29 for details.]
2 Perform "Setting the clock" from the beginning.