Sherwood CDC-5506 Introduction, Read this Before Operating Your Unit, Canada, FCC Information

CDC-5506 (A)_ENG_11-11-21:CDC-5506(A)_ENG 2011-11-21 오￿ 4:59 페이지 3

Introduction

READ THIS BEFORE OPERATING YOUR UNIT

		This symbol is intended to alert the user to the presence of
		uninsulated "dangerous voltage" within the product's
		enclosure that may be of sufficient magnitude to constitute
		a risk of electric shock to persons.
CAUTION	: TO REDUCE THE RISK OF ELECTRIC SHOCK,
		This symbol is intended to alert the user to the presence of
	DO NOT REMOVE COVER (OR BACK).
	NO USER-SERVICEABLE PARTS INSIDE.	important operating and maintenance (servicing)
	REFER SERVICING TO QUALIFIED SERVICE
		instructions in the literature accompanying the appliance.
	PERSONNEL.

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Caution regarding installation

Note : For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure. Be sure to leave a space around this unit equal to, or greater than, shown below.

Left, right and rear sides : 20 cm, top side : 40 cm.

Do not block ventilation openings or stack other equipment on the top.
Note to CATV System Installer :	FOR YOUR SAFETY
This reminder is provided to call the CATV system	U.S.A
installer’s attention to Article 820-40 of the NEC that		120 V
	CANADA
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
	Units shipped to the U.S.A and CANADA are designed for
connected to the grounding system of the building, as
close to the point of cable entry as practical.	operation on 120 V AC only.
	Safety precaution with use of a polarized AC plug.
FCC INFORMATION
	However, some products may be supplied with a nonpolarized plug.
This equipment has been tested and found to comply	CAUTION : To prevent electric shock, match wide blade of
with the limits for a Class B digital device, pursuant to
	plug to wide slot, fully insert.
Part 15 of the FCC Rules. These limits are designed to	ATTENTION : Pour éviter chocs électriques, introduire la lame la
provide reasonable protection against harmful
interference in a residential installation. This equipment	plus large de la fiche dans la borne correspondante
	de la prise et pousser jusqu’ au fond.
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance	CAUTION
with the instructions, may cause harmful interference to	• Leave a space around the unit for sufficient ventilation.
radio communications. However, there is no guarantee
that interference will not occur in a particular	• Avoid installation in extremely hot or cold locations, or in an area
	that is exposed to direct sunlight or heating equipment.
installation. If this equipment does cause harmful
	• Keep the unit free from moisture, water, and dust.
interference to radio or television reception, which can
	• Do not let foreign objects in the unit.
be determined by turning the equipment off and on, the
	• The ventilation should not be impeded by covering the ventilation
user is encouraged to try to correct the interference by
	openings with items, such as newspapers, table-cloths, curtains, etc.
one or more of the following measures:
	• No naked flame sources, such as lighted candles, should be
• Reorient or relocate the receiving antenna.
	placed on the unit.
• Increase the separation between the equipment and
	• Please be care the environmental aspects of battery disposal.
receiver.	• The unit shall not be exposed to dripping or splashing for use.
• Connect the equipment into an outlet on a circuit	• No objects filled with liquids, such as vases, shall be placed on
different from that to which the receiver is connected.	the unit.
• Consult the dealer or an experienced radio/TV	• Do not let insecticides, benzene, and thinner come in contact with
technician for help.	the set.
Caution : Any changes or modifications in construction	• Never disassemble or modify the unit in any way.
of this device which are not expressly	■Notes on the AC power cord and the wall outlet.
approved by the party responsible for	• The unit is not disconnected from the AC power source(mains) as
	long as it is connected to the wall outlet, even if the unit has been
compliance could void the user’s authority to
	turned off.
operate the equipment.
	• To completely disconnect this product from the mains, disconnect
This Class B digital apparatus complies with Canadian	the plug from the wall socket outlet.
	• When setting up this product, make sure that the AC outlet you
ICES-003.
	are using is easily accessible.
Cet appareil numérique de la Classe B est conforme à
	• Disconnect the plug from the wall outlet when not using the unit
la norme NMB-003 du Canada.
	for long periods of time.

ENGLISH

3