Sherwood DS-10 manual Troubleshooting Guide, Specifications

Models: DS-10

1 18
Download 18 pages 47.29 Kb
Page 17
Image 17

DS-10(A)_ENG_090212:DS-10(A)2009-02-19오￿10:43페이지17

Troubleshooting Guide

If a fault occurs, run through the table below before taking the iPod Dock for repair.

If this fails to resolve the situation, consult your dealer. Under no circumstances should you attempt to repair the iPod yourself. This could void the warranty.

 

 

 

 

ENGLISH

PROBLEM

POSSIBLE CAUSE

Dock properly.

 

REMEDY

 

 

No sound

• The iPod does not work.

• Make sure iPod is playing actually.

 

 

 

• The iPod is not inserted into the iPod Dock.

• Make sure iPod is inserted into the iPod

 

 

 

• The connected receiver is turned off.

• Make sure the receiver is turned on.

 

 

 

 

 

• Incorrect selection of input source on the

• Select the desired input source correctly.

 

 

 

receiver.

 

 

 

 

• The receiver's volume is adjusted too low.

• Adjust the receiver's volume.

 

 

 

• The audio cables are disconnected.

• Make connections correctly.

 

 

 

• Poor connection at AC wall outlet or the

• Check the outlet using a lamp or another

 

 

 

outlet is dead or off.

appliance.

 

 

 

 

 

 

 

The iPod Dock's remote

• The remote sensor is obstructed.

• Remote th obstacle or move iPod Dock.

 

 

control doesn't control.

 

• Point the remote control toward the iPod

 

 

 

 

Dock.

 

 

 

• Battery is not loaded or exhausted.

• Replace the battery.

 

 

 

 

 

 

 

The receiver's remote

• The iPod is not inserted into the iPod Dock.

• Make sure iPod is inserted into the iPod

 

 

control doesn't control.

 

Dock properly.

 

 

 

• "DOCK" button is not pressed as a "DEVICE"

• Press the "DOCK" button.

 

 

 

button first before controlling iPod.

 

 

 

 

• The receiver's remote control doesn't point

• Point it toward the receiver.

 

 

 

toward the receiver.

 

 

 

 

• Incorrect connections between the iPod

• Connect iPod to iPod Dock with both a Digi

 

 

 

Dock and the receiver.

Link-I cable and an audio cable.

 

 

 

 

 

 

 

No OSD on the TV

• The OSD mode is off.

• Set the OSD mode to On.

 

 

 

• TV system is different from that of the TV.

• Change the TV system to NTSC or PAL.

 

 

 

• The video output mode is not set correctly.

• Set the video output mode correctly

 

 

 

 

according to video connection between the

 

 

 

 

receiver and the iPod Dock.

 

 

 

 

 

 

 

Specifications

GENERAL

 

• Power supply

AC Adapter (DC 5V 1.5A)

• Power consumption

(iPod not inserted) 0.8 W

• Dimensions (W× D× H, including protruding parts) 120 × 122.8 × 31 mm(4-3/4× 4-7/8× 1-1/4 inches)

• Weight (Net) 305 g ( 0.67 Ibs)

Note: Design and specifications are subject to change without notice for improvements.

17

Page 17
Image 17
Sherwood DS-10 manual Troubleshooting Guide, Specifications