Operations
LISTENING TO A PROGRAM SOURCE
Before operation
Enter the standby mode.
MAIN POWER
ON/ OFF
The STANDBY indicator lights up.
This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.
To switch the power completely off, push the POWER switch again.
The power is cut off and the STANDBY indicator goes off.
In the standby mode, turn the power on.
1
POWER
STANDBY
ON/STANDBY
or
Each time the STANDBY button on the front panel or the POWER button on the remote control is pressed, the receivers turns on to enter the operating mode or off to enter the standby mode.
In the standby mode, if the INPUT SELECTOR button is pressed, the receiver turns on automatically and the desired input is selected.
Switch the speakers on.
2 | SPEAKER |
| ON/OFF |
The SPEAKER indicator lights up and sound can be heard from the speakers connected to the speaker terminals.
When using headphones for private listening, press the SPEAKER button again to switch the speakers off.
Select the desired input source.
3
| INPUT SELECTOR |
|
| |
AUDIO | VIDEO | TAPE MON. | CD | TUNER VIDEO1 |
|
|
| AUX | TAPE MON. VIDEO2 |
|
|
| or | VIDEO3 |
Each time the “AUDIO” button is pressed, the input source changes as follows;
TUNER CD AUX (frequency display)
Each time the “VIDEO” button is pressed, the input source changes as follows;
VIDeo 1 | VIDeo 2 | VIDeo 3 |
When the TAPE MONITOR button is set to on so that “TAPE M” indicator lights up, other inputs can not be heard from the speakers.
To listen to an input source other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.
TAPE MONITOR function
You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.
To listen to the component connected to these jacks, set the TAPE MONITOR button to on.
If you connect a
For further details, refer to the operating instructions of the component connected.
When selecting the 6 CH DIRECT as desired,
6CH DIRECT
or
6CH DIRECT
To cancel the 6 DIRECT function, press the 6 CH DIRECT button again or select another desired input source.
These 6 separate analog signals can be heard, only. They cannot be recorded.
ENGLISH
11