Sherwood RX-4100 manual Tuning to preset stations, Listening to FM stereo broadcasts, English

	Select the desired preset number (1~30) and					Repeat the above steps 1 to 3 to memorize
3	press the MEMORY button.				4	other stations.
		MEMORY		MEMORY
TUNING/PRESET			or
When using the NUMERIC buttons on the remote					MEMORY BACKUP FUNCTION
control.		3			The following items, set before the receiver is turned
Examples)		For “3” :
					off, are memorized.
		1	within 2 seconds	5
					INPUT SELECTOR settings
		For “15” :
		0			Preset stations,etc.
		For “30” :
					Note
The station has now been stored in the memory.
					If the electricity fails or the AC input cord is
When using the NUMERIC buttons, the station is
					disconnected for more than 2 weeks, they are all
stored automatically without pressing the MEMORY
					cleared. So you should memorize them again.
button.
A stored frequency is erased from the memory by
storing another frequency in its place.
If “MEMO” goes off, start again from the above step 2.
Tuning to preset stations						Select the desired preset number.
					2
	After selecting the tuner as an input					TUNING/PRESET
1 source, select the preset mode.					When using the NUMERIC buttons on the remote
		T/P MODE			control.				3
					Examples) For “3” :
						For “15” :			1	within 2 seconds	5
						For “30”	:		0
Then “CH” lights up.					When selecting the desired preset number with the
					NUMERIC buttons, the desired preset station will be
					tuned to automatically without selecting the preset
					mode.
Listening to FM stereo broadcasts					Scanning preset stations in sequence
While listening to FM broadcasts.
				FM MODE		1	2	3	4
						POWER		A SPEAKER B
						5	6	7	8
						9	0	FM MODE MEMORY
						DISPLAY	SLEEP	P.SCAN	TUNER	P.SCAN
						CD	TAPE	VCR	AUX
						AUDIO CONTROL		TONE SEL
						BALANCE		MUTE	VOLUME
Each time this button is pressed,						REMOTE CONTROL UNIT RM-101
the FM mode changes as follows:
Stereo mode : “STEREO” lights up.
Mono mode : “STEREO” goes off.
When FM stereo broadcasts are poor because of					The receiver will start scanning the stations in the preset
weak broadcast signals, select the FM mono mode to					sequence and each station is received for 5 seconds.
reduce the noise, then FM broadcasts are reproduced					At the desired station, press this button again to stop
in monaural sound.					scanning.

ENGLISH

1 3