Operations
LISTENING TO A PROGRAM SOURCE
Before operation
• Push the POWER switch.
• This unit enters the standby mode and the STANDBY indicator lights up. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
• To switch the power off, push the POWER switch again. Then the power is cut off and the STANDBY indicator goes off.
1. In the standby mode, turn the power on.
| • Each time the POWER ON/STANDBY button on the front | |
| panel is pressed, the receiver is turned on to enter the | |
or | operating mode or off to enter the standby mode. | |
• On the remote control, press the POWER ON button to | ||
| ||
| enter the operating mode or press the STANDBY button to | |
| enter the standby mode. | |
| • In the standby mode, if the INPUT SELECTOR button on | |
| the remote control is pressed, the receiver is turned on | |
| automatically and the desired input is selected. |
2. Switch the desired speakers on.
• Then the corresponding speaker indication ("SPK A or B") is displayed and the sound can be heard from the speakers connected to the selected speaker terminals.
• When using the headphones for private listening, press the corresponding SPEAKER button to switch off both A and B speakers.
3. Select the desired input source.
ENGLISH
•Each time the INPUT SELECTOR knob is rotated, the input source changes as follows :
→TUNER ↔ CD ↔ TAPE ↔ AUX ←
(Frequency display)
→ EXT IN ↔ BT IN ↔ F AUX ←
•Each time the BAND button or the TUNER button is pressed, the band changes as follows:
→FM ST → FM MONO → AM
•When selecting the EXTERNAL IN, 6 seperate analog signals from the component connected to this input pass through the tone and volume circuits only and can be heard from your speakers.
•These analog signals can be heard only, not recorded.
13
