Shindaiwa 80045 manual Contents, Introduction, Prior to Assembly, 75RS Specifications

Notes

Contents
	PAGE
Introduction	1
Assembly	2
Operation	4
Settings	6
Rate Conversion	7
Maintenance	8
Fasteners	9
Illustrated Parts List	10
Warranty Statement	11

Introduction

The information contained in this manual describes machines available at the time of production. While every attempt has been made to provide the very latest information about the 75RS, there may be some differences between your spreader and what is described here. Shindaiwa Inc. reserves the right to make changes in production without prior notice, and without obligation to make alterations to spreaders previously manufactured.

If you have any questions regarding your 75RS Spreader, or if you do not understand something in this manual, your Shindaiwa dealer will be glad to assist you. For additional information, you may contact Shindaiwa Inc. at the address printed on the back of this manual.

Prior to Assembly

IMPORTANT!

The terms “left,” “left-hand,” and “LH”; “right,” “right-hand,” and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation of the spreader.

Before assembling the spreader, make sure you have all required components. See pages 9 and 10.

■Hopper assembly

■Drive wheel

■Free wheel

■Frame, axle and gearbox assy.

■Handle tube

■T-handle assembly

■Handle braces (2)

■Control rod and wire assembly

■Hardware bag (see page 9 for contents)

■This manual, part number 80045

Carefully inspect all components for damage.

75RS Specifications

Dimensions
Overall height		22" (55.9 cm)
Wheel track width		22" (55.9 cm)
Handle length		31" (78.7 cm)
Dry weight		18.3 lbs. (8.3 kg)
Hopper capacity
..... ................	1.3 cubic feet (36.8 liters)
Tires	10" (254 mm) dia., pneumatic
Axle bearing		Nylon
Frame		7/8" (22.2 mm)
(welded steel tube)

12 1