Shindaiwa 81010 manual Product Description, Specifications T272/T272X, Prior to Assembly

Product Description

Using the accompanying illustrations as a guide, familiarize yourself with your unit and its various components. Understanding your unit helps ensure top performance, long service life, and safer operation.

WARNING!

Do not make unauthorized modifica- tions or alterations to either of these

Ignition	T272 Grass Trimmer
		Spark Plug
Switch
Handle	Grip
Outer Tube		Fuel
	Throttle
		Tank
	Trigger

Gear Case

units or their components.

Trimmer Head

Gear Case

	T272X Grass Trimmer
Cutting	Spark Plug
Attachment Shield
	Cylinder
	Ignition Cover
	Switch

		Fuel
		Tank
	Handle
	Barrier Bar	Throttle
Outer Tube		Trigger

Cutting

Attachment Shield

Trimmer Head

Figure 4

Specifications T272/T272X

Engine Code	S272E Engine
Dry weight, T272	14.7 pounds/6.7 kg
(less attachment)
Dry weight, T272X	14.8 pounds/6.7 kg
(less attachment)
Type	2-cycle, vertical-cylinder, air-cooled
Bore x Stroke	1.3 in. x 1.2 in./34 mm x 30 mm
Displacement	1.7 cu. in./27.2cc
Maximum Power Output	1.1 kw/1.4 hp

Spark Plug	Champion CJ8Y
Air Cleaner Type	Non-reversible heavy-duty filter element
Starting Method	Recoil starter
Stopping Method	Slide switch, grounding type
Handle (T272)	Loop handle
Handle (T272X)	Loop handle with barrier bar
EPA Emission
Compliance Period**	Category A

Operating RPM Range	..................................4,500-9,000 RPM (min-1)
Transmission Type	Automatic centrifugal clutch
	through bevel gears
Fuel/Oil Ratio	50:1 with ISO-L-EGD or JASO
	FC class 2-cycle mixing oil*
Fuel Tank Capacity	670ml/22.6 ounces
Carburetion	Walbro diaphragm-type
Ignition	Fully electronic, transistor controlled

**The EPA emission compliance referred to on the emission compli- ance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

* meets or exceeds these specifications and is recommended for all Shindaiwa Products.

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a com- plete unit and inspect unit and compo- nents for any damage.

Engine and shaft assembly.

Cutting attachment shield.

Cutting attachment.

Kit containing cutting attachment shield bracket and hardware, this owner’s/op- erator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench set, spark plug/screwdriver combination wrench and a spanner.

IMPORTANT!

The terms “left,” “left-hand,” and “LH”: “right,” “right-hand,” and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation of this product.

5