Shindaiwa manual Specifications T272X/C272, Assembly and Adjustments Handle T272/T272X

Specifications T272X/C272

Engine Code	S272E Engine	Carburetion		Walbro diaphragm-type
Dry weight, T272		Ignition	Fully electronic, transistor controlled
(less attachment)	6.7kg/14.7 pounds	Spark Plug		Champion CJ8Y
Dry weight, T272X	6.7kg/14.8 pounds	Air Cleaner Type		Non-reversible heavy-duty
(less attachment)				filter element
Type	2-cycle, vertical cylinder, air cooled
		Starting Method		Recoil
Bore x Stroke	34 mm x 30 mm/1.3 in. x 1.2 in.
		Stopping Method	Slide switch, grounding type
Displacement	27.2cc/1.7 cu. in.	Handle		Loop handle (T272)
Maximum Power Output	1.1 kw/1.4 hp		Loop handle with barrier bar (T272X)
Operating rpm Range	4,500-9,000 rpm (min-1)
		EPA Emission Compliance Period**		...........................Category A
Transmission Type	Automatic centrifugal clutch	* Shindaiwa One meets or exceeds these specifications and is recommended
	through bevel gears
Fuel/Oil Ratio	50:1 with ISO-L-EGD or JASO	for all Shindaiwa Products
		** The EPA emission compliance referred to on the emission compliance label lo-
	FC class 2-cycle mixing oil*
		cated on the engine, indicates the number of operating hours for which the engine
Fuel Tank Capacity	670ml/22.6 ounces	has been shown to meet Federal emission requirements. Category C = 50 hours
		(Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

nEngine and shaft assembly

nCutting attachment shield

nCutting attachment

nKit containing cutting attachment shield bracket and hardware, this owner's/ opertor's manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench set, spark plug/screwdriver combination wrench and a spanner.

IMPORTANT!

The terms “left,” “left-hand,” and “LH”: “right,” “right-hand,” and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation of this product.

Assembly and Adjustments Handle T272/T272X

The handle is attached to the outer tube on the T272/T272X.

To Adjust the Handle.

1.Loosen the 4 socket-head capscrews on the handle. See Figure 5.

2.Position the handle forward of the Handle Positioning Label at the best position for operator comfort (usually about 10 inches ahead of the throttle housing).

3.Secure the handle by alternately tight- ening the four socket-head cap screws in a diagonal or “criss-cross” fashion.

4 Socket-head Cap-

screws

Handle

Outer Tube

Barrier

Bar

Handle Positioning Label

T272X Shown

Figure 5