Shindaiwa T272X manual Hour Maintenance, Every 135 hours of operation

Models: T272 T272X

1 40
Download 40 pages 5.07 Kb
Page 14
Image 14
50-Hour Maintenance

50-Hour Maintenance

Every 50 hours of operation (more frequently in dusty or dirty conditions):

nRemove and clean the cylinder cover and clean grass and dirt from the cylinder fins.

nRemove the cutting attachment, cutting attachment holder and gear shaft col- lar. Remove the filler plug from the side of the gearcase and press new grease into the gearcase until the old grease is pushed out. Use only lithium-base grease such as Shindaiwa Gear Case Lubricant or equivalent. See Figure 29.

New Grease

Old

 

Grease

nUse a hooked wire to extract the fuel filter from inside the fuel tank. See Fig- ure 30. Remove and replace the filter element. Before reinstalling the filter, inspect the condition of the fuel line.

If damage or deterioration are noted, the unit should be removed from service until it can be inspected by a Shindaiwa-trained service technician.

CAUTION!

Make sure you do not pierce the fuel line with the end of the hooked wire. The line is delicate and can be dam- aged easily.

Hooked

Wire

Figure 30

Gear Shaft Collar

Figure 29

135-Hour Maintenance

Every 135 hours of operation,

remove and clean the muffler.

135-Hour MaintenanceWARNING!

Never operate this unit with a dam- aged or missing muffler or spark

5.Remove the spark arrester screen and clean with a stiff bristle brush.

6.Gently tap the muffler on a wood sur- face to dislodge any loose carbon.

7.Inspect the cylinder exhaust port for carbon buildup.

IMPORTANT!

If you note excessive carbon buildup, con- sult with an authorized servicing dealer.

8.Reassemble the muffler in the reverse order of disassembly.

arrester! Operating with missing or damaged exhaust components is a fire hazard and could also damage your hearing.

1.Remove the spark plug boot.

2.Remove the four 4 mm engine cover screws (two in the back and two in the front of the cover) and lift the cover from the engine.

3.Remove the two 5 mm muffler screws. Remove the lower muffler screw, then lift the muffler assembly from the engine.

4.Seperate the muffler from the forward muffler shield, while observing the orientation of the components.

See Figure 31.

Rear Muffler

 

Spark Ar-

 

Shield

 

Forward

 

rester Screen

 

 

 

 

Muffler

 

 

 

 

 

 

Shield

 

 

 

5 mm Muffler

 

 

 

Screws

Rear Muffler

 

 

 

Shield Screw

 

 

 

 

Muffler

 

Lower Muffler

 

 

Screw

Figure 31

 

 

 

 

 

14

Page 14
Image 14
Shindaiwa T272X manual Hour Maintenance, Every 135 hours of operation