The front I/O assembly is attached to the front of the chassis. Pull the assembly away from the chassis to remove it.
1.Prepare the computer for disassembly (Preparation for Disassembly on page 22).
2.Remove the access panel (Access Panel on page 23).
3.Remove the front bezel (Front Bezel on page 24).
4.Disconnect the front audio and front USB cables from the yellow and white system board connectors.
5.Press down the latch (1) to release front I/O assembly, and then slide the assembly right and
pull it away from the front of the chassis while threading the wires through the hole in the chassis
Figure
1
To install the front I/O assembly, reverse the removal procedure.
NOTE: Be sure to correctly route the cables when reinstalling the assembly. Proper cable routing prevents damage to the cables and promotes proper air flow.
33