2 Computer Setup (F10) Utility

Computer Setup (F10) Utilities

Use Computer Setup (F10) Utility to do the following:

Change factory default settings.

Set the system date and time.

Set, view, change, or verify the system configuration, including settings for processor, graphics, memory, audio, storage, communications, and input devices.

Modify the boot order of bootable devices such as hard drives, optical drives, or USB flash media devices.

Select Post Messages Enabled or Disabled to change the display status of Power-On Self-Test (POST) messages. Post Messages Disabled suppresses most POST messages, such as memory count, product name, and other non-error text messages. If a POST error occurs, the error is displayed regardless of the mode selected. To manually switch to Post Messages Enabled during POST, press any key (except F1 through F12).

Enter the Asset Tag or property identification number assigned by the company to this computer.

Enable the power-on password prompt during system restarts (warm boots) as well as during power-on.

Establish a setup password that controls access to the Computer Setup (F10) Utility and the settings described in this section.

Secure integrated I/O functionality, including the serial, USB, or parallel ports, audio, or embedded NIC, so that they cannot be used until they are unsecured.

Enable or disable removable media boot ability.

Solve system configuration errors detected but not automatically fixed during the Power-On Self- Test (POST).

Replicate the system setup by saving system configuration information on a USB device and restoring it on one or more computers.

Execute self-tests on a specified ATA hard drive (when supported by drive).

3