Starting the Engine
IMPORTANT!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP.
WARNING!
The attachment will operate immediately when the engine starts and could result in loss of control and possible serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown.
WARNING!
Never start the engine from the operating position.
1. Slide the ignition switch to the “I” position.
ON
Slide ignition to ON
2.Press the primer bulb until fuel can be seen flowing in the transparent return tube.
3.Set the choke lever to the CLOSED position if engine is cold.
4.While holding the outer tube firmly with left hand. Use your other hand to slowly pull the recoil starter handle until resistance is felt, then pull quickly to start the engine.
IMPORTANT!
The primer system only pushes fuel through the carburetor. Repeatedly pressing the primer bulb will not flood the engine with fuel.
Primer Bulb
Return
Tube
Press primer bulb...
Closed 
Move the choke lever to the
CLOSED position
Hold
the unit
firmly...
...and pull recoil | Make sure the | |
starter handle | ||
attachment is clear | ||
upward | ||
of obstructions! | ||
|
11
