Shindaiwa X7502825601, C254 manual Emission Control Exhaust & Evaporative, Prior to Assembly

Emission Control (Exhaust & Evaporative)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to California models only.

An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en- gine FAMILY).

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.

Assembly

This unit comes fully assembled with the exception of the handlebar, cut- ting attachment shield and cutting attachment.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

■■Engine/Outer tube assembly

■■Handlebar and Throttle assembly ■■Cutting attachment shields

■■Cutting Attachment

■■Shoulder Strap w/Hip Pad

■■Cutting attachment shield mounting brackets and assembly hardware

■■Cutting attachment adapter plates

■■4 mm hex key wrench (Also use as a locking tool)

operation.

Handlebar Assembly

Install the handlebar:

1.Remove four (4) upper cap retaining screws, and remove upper cap from handlebar mounting bracket.

2.Place handlebar on mounting bracket, and secure with upper cap and four (4) screws.

3.Adjust handlebar position for best operator comfort and control, then tighten upper and lower cap retain- ing screws securely.

4.Secure cable to outer tube with two

(2) bands provided.

		■■T-wrench
Throttle lock	Ignition switch
button
		Throttle interlock
Throttle
trigger		Handlebar
Throttle		Handle bar
		Upper cap
Assembly
		retaining screws
	Handle positioning	Upper	Hanger
	label	cap
	Outer tube
	Lower cap
	retaining
	screws		Bands
		Lower cap
Mounting the brushcutter handlebar

6