GMP
ISO9001
ISO14001
ISO13485
CERTIFIED
DISASSEMBLY & ASSEMBLY INSTRUCTIONS
DISASSEMBLY PROCEDURES
WARNING! We advise caution when disassembling and lifting items. You must ensure that the person undertaking these actions is able to handle the weight.
STEP 1 Ensure the area where the Powerchair is to be dismantled is spacious. STEP 2 Remove the plug at the end of the VSI cable by pulling on the pull ring.
CAUTION! Lay the plug down carefully, taking care not to damage the chassis shroud.
STEP 3 The arm assembly can be removed to make the seat assembly lighter to lift. Under the rear of the seat assembly there are two hand knobs. Release these by turning in a
STEP 4 The seat assembly should be folded down for easier lifting.
STEP 5 For WIZZ (888WNL), loosen and take away the retaining pins from the four seat supporting posts beneath the seat assembly.
For STREAMER (888WB/888WAB/888WSB), release and take away the hand knob from the seat supporting post.
STEP 6 For
STEP 7 Lift the seat assembly free of the chassis assembly.
STEP 8 Remove the chassis shroud by simply lifting up. You will find the shroud is held firm by Velcro tapes.
CAUTION! Care must be taken to slide the plug through the chassis shroud.
STEP 9 For WIZZ (888WNL), loosen and take away the two retaining pins securing the connection between front chassis assembly and rear chassis assembly.
STEP 10For STREAMER (888WB/888WAB/888WSB), loosen and take away the two retaining pins securing the connection between chassis assembly and
STEP 11Unclip the battery plugs (red and black). The batteries can now, with the help of carrying straps provided, be lifted from chassis.
To reassemble the Powerchair, reverse the procedures described above.
~20~