ADJUSTMENTS
Tiller Angle Adjustment (For XtraLite 4 & Sunrunner S ONLY) (Fig. 5)
On the left hand side at the base of the tiller is a red lever. Push the lever in to release the pin and select the required tiller angle. Refit the pin into one of the five location holes.
Folding the Tiller (For XtraLite 3 & Scootie ONLY) (Fig. 6)
Fold down the tiller by loosening the hand knob located at the base of the tiller stem.
Seat Slide & Swivel Adjustment (For Sunrunner S ONLY) (Fig. 7)
Pulling up on the lever allows the seat position to be adjusted forward or backward. Release the lever and the seat will lock in that position. Under the right side of the seat there is a spring loaded red lever. Pulling up on the lever allows the seat to swivel, when released the seat will lock into one of 4 positions.
Seat Removal (Fig. 8)
Fold down the back of the seat. Remove the seat hand knob and locking pin that secures the seat adaptor. Lift the seat adaptor out of the seat post.
Seat Height Adjustment (Fig. 8)
Remove seat as described above. Loosen the lower hand knob. The seat height can be adjusted to 5 different settings by inserting the steel locking pin in the required hole. Retighten the lower hand knob and replace the seat.
Do not use the scooter without the arms
being fitted.
Tiller Angle
Adjustment
Lever
Figure 5
Tiller Hand
Knob
Figure 6
Seat Slide
Lever
Figure 7
Seat
Adaptor
Seat
Tightening
Hand Knob
Figure 8
Swivel Seat
Adjustment
Lever
Seat Locking Pin
9/22/2004 | 7 |
