Shoprider UL8W36 manual Battery Charging Procedure, Battery on chair charging method

Battery Charging Procedure

There are two ways to charge the Trooper Powerchair

Battery on chair charging method

1)Plug the A/C power cord into the wall. Plug the male three-pin charger plug into the female 3-pin receiver located on the bottom of the VSI (Refer to Figure 3, #8).

Battery off chair charging method

2)Remove the battery-pack from the unit. Plug the A/C power cord into the wall. Located on the battery-pack is a charger port. Slide the charger port cover over to expose the charger female 3-pin receiver. Plug the male three-pin charger plug into the female 3-pin receiver. It is not necessary for the battery-pack to be attached to the Powerchair to charge.

The battery charger’s light indicator is as follows:

One light charger (4Amp)

Yellow/Amber -Charging

Green - Charging complete

NOTE: It is very important to check the charger light color. IF there is no light or a different color light on than should be, refer to the charging troubleshooting section in this manual. amount of battery Depending on the amount of battery discharge, the charge can take up to 12 hours. The battery charger has an electronic switch that will terminate the charge when the batteries are fully charged. Do not remove the battery charger until the charging cycle is complete. Be sure to unplug the charger from the wall first before unplugging charger from the Powerchair.

WARNING! Only use the original manufacturer approved charger!

This charger is for indoor use only. Do not expose it to rain or water spray.

Do not leave the charger plugged into the Charging Port if the charger is not charging.

3/13/2008 19