Shure 27C8642 Specifications, Furnished Accessories, Optional Accessories, Replacement Parts

ENGLISH

SPECIFICATIONS AND INFORMATION

Specifications

RF Carrier Frequency Range

169.445 to 216.000 MHz

Working Range

100 m (approximately 300 ft) under typical conditions.

Audio Frequency Response

50 to 15,000 Hz, ±2 dB

Audio Output Level (±15 kHz deviation, 1 kHz tone) 1/4 inch connector (into 3 k￿ load) -8.8 dBV (Hi Z)

Audio Connectors

Model:	T88	T1
Connector Type:	1/4-inch	4-Pin miniature
	phone plug	connector
	(female)	(TA4F)
Configuration:	active	active
	unbalanced	unbalanced
Actual	3 k￿	18 k￿
Impedance:		with lavalier
Maximum	-	12.2 dBu
Input Level:
Maximum	0 dBu	-
Output Level:
Pin	Tip = hot	pin 1= ground
Assignments:		pin 2 = +5 V
	sleeve = ground	pin 3 = audio
		pin 4 = through
		20 k￿ resistor
		to ground
Phantom Power	yes	-
Protection:
Voltage:	-	+5 V

RF Sensitivity

-101 dBm typical

System Distortion (ref. ±15 kHz deviation, 1 kHz modulation) 0.7%

Power Requirements

T1, T2/14A: 9V alkaline battery (Duracell MN1604 recommend- ed). 8.4V Nicad (rechargeable) are optional but not recom- mended.

T88: 12 Vdc (PS20, 120Vac; PS20E, 230 Vac Power Supply)

Current Drain

T1: 31 mA average (40 mA max)

T2/14A: 30 mA average (35 mA max)

T88: 160 mA average (195 mA max)

Operating Temperature Range

-20°to 50°C (-4°to 122° F). NOTE: Battery characteristics may limit this range.

Overall Dimensions

T1: 82.6 mm H x 63.5 mm W x 26.2 mm D

T2/14A: 241 mm L x 50.8 mm Dia.

T88: 44 mm H x 349 mm W x 194 mm D

Net Weight

T1: 79.5 g without battery

T2/14A: 294.8 g without battery

T88: 435 g

Certification

T1, T2: Type-accepted under FCC Parts 90 and 74; IC certified under TRC-78

T88: Approved under the Notification provision of FCC Part 15

PS20 Power Supply: Conforms to safety standard UL1310. Canada/CSA 22 2 No. 223.

PS20E Power Supply: Conforms to safety standard EN 60065

PS20UK Power Supply: Conforms to safety standard EN 60065.

Furnished Accessories

Plastic Screwdriver	65A1659
Swivel Adapter (hand-held only)	WA370A
Anti-Roll Device (hand-held only)	66A8043

Optional Accessories

T1 Pin Connections

MICROPHONE

ELEMENT

2

4

3

1

T1 MIC JACK BOARD
500	+5 V
2
	27 pF
4
20K
500	AUDIO
3
27 pF	GROUND
1

Microphone Adapter Cable (T1)		WA310
4-Pin Female Mini Connector TA4F (T1)		WA330
In-Line Audio Switch (T1)		WA360
1.8	Meter (6 ft.) Receiver-Mixer Cable	WA410
6.1	Meter (20 ft.) Antenna Extension Cable	WA421

Replacement Parts

14A Cartridge with Grille		.........................................R200
AC Adapter	PS20 (120 Vac)/PS20E (230 Vac)
Grille (T2/14A)		RK143G

NOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER; GUITAR CABLE DOES NOT.

T88 Output Wiring (1/4 inch male plug to output connector)

SLEEVE

TIP +

Gain Adjustment Range

T1: 40 dB

T2/14A: 25 dB

RF Power Output

T1, T2/14A: 50 mW maximum (complies with FCC and IC regulations)

Belt Clip (T1)	53A8247A
1/4 Wave Antenna	90A8380

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

6